Feixun N1 does a detailed tutorial on side-route

time：2025-03-29 15:02:36 Tech Trends

Phicomm router N1 side routing settings

The bypass routing of the Feixun N1 router is set up in the following situations:

1. The primary dial-up router acts as a DHCP server, which is responsible for dynamically assigning IP addresses. In this case, only the network-interface-LAN of OpenWrt needs to be set to dynamic IP mode.

2. Set the primary route to static IP mode. After the settings are complete, set the delivery gateway to the N1 address in the DHCP Settings section of the primary route. In OpenWrt, you can set the following settings and fill in "3, gateway IP" in the DHCP option without double quotation marks.

3. N1 when the primary router dials + switches + AP settings. In general, plug the home network cable into any port of the switch, and connect one of the remaining ports to N1 with a network cable, and the other network cables can be directly connected to the switch. By default, N1 enables AP. If you configure a PC access switch, the IP address will be automatically obtained, and the default management address of N1 is the gateway address obtained.

4. N1 dials as the primary router and acts as the AP itself. The settings are as follows: connect to OpenWrt on N1, go to Network-Interface-lan-Advanced Settings, cancel the bridge, select Wi-Fi, and click Save. Go back to the network, click Interfaces, find Add Interface, set the name to wan, select PPPoE as the protocol, save and apply.

Please refer to the original article for details on how to set it up.

# Tech Trends #

《Feixun N1 does a detailed tutorial on side-route》 This does not represent the views of this website. If there is any infringement, please contact us to delete it.

Latest article

Recommend

Ranking